Package contents, Skid, Step i – unpacking and checking contents – DR Power TPH-184CHP User Manual
Page 10: Step ii – assembling the chipper hopper, Assembly

SECTION II - ASSEMBLY & INSTALLATION
PACKAGE CONTENTS
SKID
POLY BAG
BOLT BAG
PART #
WHERE USED
SHREDDER/CHIPPER
OWNER’S MANUAL
1 EA – ¼” X ¼” X 1 ½” KEY
080-0080
PTO SHAFT
CHIPPER HOPPER
WARRANTY CARD
4 EA – 5/16-18 X ¾” CARRIAGE BOLT
090-0462
CHIPPER HOPPER
SHREDDER HOPPER
SAFETY GLASSES
4 EA – 5/16 FLAT WASHERS
090-0233
CHIPPER HOPPER
P.T.O. DRIVE SHAFT
BOLT BAG
8 EA – 5/16-18 NYLOCK NUT
090-0460
4 EA – CHIPPER HOPPER
4 EA – SHREDDER HOPPER
POLYBAG
2 EA – 3/8-16 X 3/8” SET SCREWS
080-0056
PTO SHAFT
2 EA – 5/16-18 X 1 ¼” HHCS
090-0089
SHREDDER HOPPER
2 EA – 5/16-18 X 1 ½” HHCS
090-0090
SHREDDER HOPPER
4 EA – ANTI-VIBRATION MOUNTS
500-0068
SHREDDER HOPPER
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION
• ½” Wrench or socket
ASSEMBLY
STEP I – UNPACKING AND CHECKING CONTENTS
• Remove the all items from the crate.
• After unpacking the crate, compare the contents with the list above.
• If any parts are missing, contact your place of purchase.
• Assembly should be done on a clean, level surface.
STEP II – ASSEMBLING THE CHIPPER HOPPER
• Assemble chipper hopper to the basic machine using four each 5/16”-18 x ¾” carriage bolts, 5/16”-18 nylock nuts
and 5/16” flatwashers from the bolt bag. Put head of bolt inside hopper with threads sticking out. Tighten all
hardware with a ½” wrench.
10