DR Power Sprint (1985 - 2000) - Manual (Page 11)

DR
®
TRIMMER/MOWER
™
Assembly & Operating Instructions 5
Assembly
WARNING: Do not attempt to start the engine until all assembly steps are complete, and you
have ADDED GAS AND OIL to the engine.
Please Note: Your trimmer may look
slightly different than some of the photos
shown in this manual.
Tools & Supplies Needed:
• flat head screwdriver
• 1/2" and 3/8" wrenches, adjustable
wrench, or socket set
• pliers
• SAE30 HD (High Detergent) motor oil
• funnel (preferably with filter)
• unleaded gasoline
Step 1: Install the Axle and Wheels
1. Turn the orange housing upside down to
access the underside. Leave the front piece
of Styrofoam in place (Figure 2).
2. Mount one wheel on the axle with the open
portion of the hub facing in toward the frame
(Figure 3).
3. Mount the retaining ring so it is flush with
the end of the axle, and tighten the set screw
(Figure 4).
Figure 2
Figure 3 Figure 4
WARNING!
THIS MACHINE IS SHIPPED WITHOUT
OIL! TRACES OF OIL MAY BE LEFT
IN THE RESERVOIR FROM FACTORY
TESTING, BUT YOU MUST ADD THE
RECOMMENDED AMOUNT OF OIL
BEFORE STARTING THE ENGINE.