Denon 1083 - Manual (Page 25)

25
NOTES:
• The OPTICAL 4 and 5 jacks on the AVR-3803/1083’s rear panel are equipped with an optical digital output jack for recording digital signals on
a CD recorder, MD recorder or other digital recorder. Use this for digital recording between a digital audio source (stereo - 2 channel) and a
digital audio recorder.
• Do not connect the output of the component connected to the OPTICAL 4 OUT jack on the AVR-3803/1083’s rear panel to any jack other than
the OPTICAL 4 IN jack.
• Do not connect the output of the component connected to the OPTICAL 5 OUT jack on the AVR-3803/1083’s rear panel to any jack other than
the OPTICAL 5 IN jack.
• “PHONO” and “TUNER” cannot be selected on the Digital In Assignment.
Setting the Video Setup
• This setting assigns the color difference (component) video input jacks of the AVR-3803/1083 for the different input sources.
[1] Setting the Component In Assign.
1 At the System Setup Menu select “Video Setup” and
press the ENTER button.
2
3
The “Video Setup” screen appears.
Select “Component In Assign.” and press the ENTER
button.
Switch to the Component In Assign. screen.
4 Select the component (Y, P B /C B and P R /C R ) video input terminal to be assigned to the input source.
Select “NONE” for sources for which the component (Y, P B /C B and P R /C R ) video input is not to be used.
When the default, “Yes”, is selected, the settings are reset to the factory defaults.
5 Press the ENTER button to complete the setting.
At the “Video Setup” screen, select “Exit” and press the ENTER button.
The System Setup Menu reappears.
q Input source selection w Component video terminal selection