Digi-Star Moisture Tracker - Manual (Page 29)

29 Moisture Tracker TM Operators Manual D3973 Rev C
MOISTURE TRACKER TM INFORMATION
Batteries
Moisture Tracker TM uses a rechargeable battery pack located in
trigger handle. To remove or change batteries, use a Phillips head
screwdriver to unscrew the cover.
IMPORTANT: Only use a battery pack supplied by Digi-Star.
Part number 408985
Low Battery
• The battery icon will begin blinking red when battery voltage is
critical (< 10%). The indicator LEDs will also flash.
• Charge battery before next use.
Charging Battery Pack
NOTE: Batteries will not charge below 32 o F (0 o C) or above
113 o F (45 o C)
• IMPORTANT: Use only AC or DC charger supplied with the
device.
• Plug AC battery charger into a 115VAC outlet.
• DC battery charger uses a 12VDC outlet.
• Charger cord connects to charging port on side of device.
• A complete charge may take up to 12 hours if device is fully
discharged.
• When fully charged, unplug the device. The displayed battery
charge level shows 4 bars.
Repair Parts
405483 USB Memory Drive (Blank)
408305 Probe Cover Grate
408883 Cig. Lighter Adapter (12VDC)
408884 AC Power Adapter
408962 USB Latch Body Cover
408963 USB Latch Tab
408970 Calibration Disk
408985 Battery Pack 7.2V NIMH
409093 USB Cover Assy.