Digi-Star Moisture Tracker - Manual (Page 10)

10 Moisture Tracker TM Operators Manual D3973 Rev C
OPERATION
Install USB Drive
Before turning on device, install USB drive in USB port. See page
11. USB drive is required when software files need updating and
data collection. Using the removable drive, data is downloaded to
a PC for analysis using Digi-Star software. Note: Turn Moisture
Tracker TM off before removing USB drive.
Updating Data Using USB Drive
(See page 30 for full procedure)
To update data, ingredient calibrations, software and firmware:
1. Load updates onto a USB drive from Moisture Tracker TM soft-
ware loaded on a PC.
2. Insert the USB drive with updates into Moisture Tracker TM .
3. Power up device and it will automatically update software and
data files.
Managing On-Board Data
To manage on-board data, the USB containing the data must
be removed from the Moisture Tracker TM and plugged into a PC
with Moisture Tracker TM software loaded.
Cleaning Probe Head and Grate
• To clean probe head of debris that may cause measurement
interference, remove probe grate by grasping grate in hand
and turn counter clockwise to release.
• Wash grate with water or wipe clean using a damp towel.
• Clean window using a clean microfiber cloth dampened with
water or methanol. Do not use window cleaner and a rag.
Avoid excess liquid in this area.
• Reinstall grate positioning it over probe head and twist clock-
wise to attach, a slight click will occur once grate is seated
properly.