Diamondback 500ER - Manual (Page 11)

500Er Owner’s Manual
11
Fig. 1. Fig. 2.
Fig. 3.
11. The handlebar pivot fixing hardware will be
pre‐installed on the console mast (C) as
shown in Fig. 2. Remove bolt H1 and washer
H2 from the left and right sides of the pivot
axle, and set aside.
12. Washer I should remain in place, on the
axle.
13. Handlebars (H6 & H7) are packaged with the
pivot covers (H4) installed. Remove the four
(4) hex fixing bolts (H5) and pivot cover (H4)
from each handlebar as shown in Fig. 2. and
set aside.
14. Ensure one piece of washer I is in place on
each side of the axle as shown in Fig. 3.
15. Install the right (H6) and left (H7)
handlebars by sliding each pivot over the
axle. Pay careful attention to the alignment
of the internal spacers as they may block
the assembly from sliding onto the axle.
Realign as necessary.
16. Fix each handlebar by reinstalling bolt H1
and washer H2, and tightening with the
enclosed box wrench.
17. Replace the left and right pivot covers (H4)
by reinstalling the hex bolts H5.