DFI RL830-C602/C604 - Manual (Page 23)

www.dfi .com
23
Chapter 2 Hardware Installation
Chapter 2
Front Panel Connector
Front Panel
R227 U19 C170 7 6
R227 U19 C170 7 6
2
1
24
23
Pins Pin Assignment Pins Pin Assignment
1 +3VDU 2 +3VDU
3 N.C 4 +5VDU
5 PWR-LED 6 x
7 +3.3V 8 x
9 HDD-LED 10 x
11 PWR-BTN 12 LED_NIC_LINK1_0_LINKUP
13 GND 14 LED_NIC_LINK1_0_ACT
15 RST-SW 16 SMB_SENSOR_3V3STBY_DATA
17 GND 18 SMB_SENSOR_3V3STBY_CLK
19 x 20 Case Open
21 +3VDU 22 LED_NIC_LINK3_2_LINKUP
23 x 24 LED_NIC_LINK3_2_ACT
HDD-LED - HDD LED
This LED will light when the hard drive is being accessed.
RESET SW - Reset Switch
This switch allows you to reboot without having to power off the system.
PWR-BTN - Power Switch
This switch is used to power on or off the system.
PWR-LED - Power/Standby LED
When the system’s power is on, this LED will light.
The pin functions of the front panel connector are listed below.