DFI RL830-C602/C604 - Manual (Page 18)

www.dfi.com
18
Chapter 2 Hardware Installation
Chapter 2
Rear Panel I/O Ports
The rear panel I/O ports consist of the following:
• 1 Serial COM port
• 1 VGA port
• 4 USB 2.0 ports
• 4 RJ45 LAN ports
LAN 1 LAN 0
USB 2.0
COM 1 VGA
LAN 2
LAN 3
COM (Serial) Ports
COM 1 and COM 2 ports are fixed at RS232. JP2 (for COM 2) is used to configure the Serial
COM port to pure RS232 or RS232 with power. Refer to “COM2 RS232/Power Select“ in this
chapter for more information.
The serial ports are RS232 asynchronous communication ports with 16C550A-compatible UARTs
that can be used with modems, serial printers, remote display terminals, and other serial
devices.
Connecting External Serial Ports
Your COM port may come mounted on a card-edge bracket. Install the card-edge bracket to
an available slot at the rear of the system chassis then insert the serial port cable to the COM
connector. Make sure the colored stripe on the ribbon cable is aligned with pin 1 of the COM
connector.
BIOS Setting
Configure the serial COM ports in the Advanced menu (“AST1400 Super IO Configuration”
submenu) of the BIOS. Refer to the chapter 3 for more information.
COM 1: RS232
R227 U19 C170 7 6
R227 U19 C170 7 6
COM 2: RS232
2 1
9
DCD-
TD
RD
DTR-
GND
RTS-
DSR-
CTS-
RI-
DCD- TD RD D
TR-
GND
1 2 3 4 5
RT
S- R
I-
DSR
-
CT
S-
6 7 8 9