DFI RL830-C602/C604 - Manual (Page 21)

www.dfi .com
21
Chapter 2 Hardware Installation
Chapter 2
I/O Connectors
SATA (Serial ATA) Connectors
• 6 Serial ATA ports (Intel ® C602J)
- 2 SATA 3.0 ports with data transfer rate up to 6Gb/s
- 4 SATA 2.0 ports with data transfer rate up to 3Gb/s
10 Serial ATA ports (Intel ® C604)
- 2 SATA 3.0 ports with data transfer rate up to 6Gb/s
- 8 SATA 2.0 ports with data transfer rate up to 3Gb/s
• Integrated Advanced Host Controller Interface (AHCI) controller
• Supports RAID 0/1/5/10
Features
SATA 2.0 3Gb/s
7
RXN GND TXP TXN GND
1
RXP GND
SATA 1
SATA 0
SATA 5 SATA 7
SATA 3.0 6Gb/s
Note:
1. SATA port 4 provides adequate space for SATA DOM.
2. SATA 6 to SATA 9 on the RL830-C604 system board do not support the DVD boot
function.
R227 U19 C170 7 6
R227 U19 C170 7 6
SATA 2 SATA 4 SATA 8 SATA 9
The Serial ATA connectors are used to connect Serial ATA devices. Connect one end of the Se-
rial ATA data cable to a SATA connector and the other end to your Serial ATA device.
BIOS Setting
Configure the Serial ATA drives in the Advanced menu (“SATA Configuration” submenu) of the
BIOS. Refer to the chapter 3 for more information.
SATA 6 SATA 3
7
RXN GND TXP TXN GND
1
RXP GND