DFI MB630-CRM - Manual (Page 44)

44
2
Hardware Installation
The S/PDIF connector is used to connect an external S/PDIF port. Your S/PDIF
port may be mounted on a card-edge bracket. Install the card-edge bracket to
an available slot at the rear of the system chassis then connect the audio cable
to the S/PDIF connector. Make sure pin 1 of the audio cable is aligned with pin 1
of the S/PDIF connector.
I/O Connectors
S/PDIF Connector
1 5
+5V
Key
SPDIF out
Ground
SPDIF in
S/PDIF