DFI MB630-CRM - Manual (Page 40)

40
2
Hardware Installation
USB Ports
USB allows data exchange between your computer and a wide range of simulta-
neously accessible external Plug and Play peripherals.
The system board is equipped with four onboard USB 3.0/2.0/1.1 ports (USB
0-3) and two onboard USB 2.0/1.1 ports (USB 8-9). The three 10-pin connec-
tors allow you to connect 6 additional USB 2.0/1.1 ports (USB 5-6/ USB 10-13).
The additional USB ports may be mounted on a card-edge bracket. Install the
card-edge bracket to an available slot at the rear of the system chassis and then
insert the USB port cables to a connector.
BIOS Setting
Confi gure the onboard USB in the Advanced menu (“USB Confi guration” sub-
menu) of the BIOS. Refer to chapter 3 for more information.
1
VCC -Data
+Data GND Ke
y
VCC
-Data
+Data
GND N. C.
2 10
9 USB 10-11
USB 0
USB 1
USB 2
USB 3
USB 12-13
USB 9
USB 8
USB 5-6
USB 3.0
USB 3.0
USB 2.0
USB 2.0