DFI NP102-N16C - Manual (Page 15)

15
2
Hardware Installation
Important:
When the Standby LED lit red, it indicates that there is power on the
system board. Power-off the PC then unplug the power cord prior to
installing any devices. Failure to do so will cause severe damage to the
motherboard and components.
System Memory
Important:
Electrostatic discharge (ESD) can damage your system board, processor,
disk drives, add-in boards, and other components. Perform the upgrade
instruction procedures described at an ESD workstation only. If such a
station is not available, you can provide some ESD protection by wearing
an antistatic wrist strap and attaching it to a metal part of the system
chassis. If a wrist strap is unavailable, establish and maintain contact
with the system chassis throughout any procedures requiring ESD pro-
tection.
DIMM
Standby LED
The system board supports one 240-pin DDR2 DIMM socket.
BIOS Setting
Configure the system memory in the Advanced Chipset Features submenu of the
BIOS. Refer to chapter 3 for more information.