DFI BT101 - Manual (Page 24)

www.dfi .com
24
Chapter 2 Hardware Installation
Chapter 2
Audio
Rear Audio
The system board is equipped with 1 audio jack. This jack is a one-hole connecting interface
for inserting a plug.
• Line-out Jack (Lime)
This jack is used to connect a headphone or external speakers.
Front Audio
The front audio connector allows you to connect to the second line-out and mic-in jacks that
are at the front panel of your system.
Driver Installation
Install the audio driver. Refer to the chapter 4 for more information.
Front Audio
1
Mic2-L
Line2-R
GND
GND NC Ke
y
2 10
Mic2-
JD
Line2-
JD
9
Mic2-R Line2-L
Line-out
I/O Connectors
SATA (Serial ATA) Connectors
• 2 Serial ATA 2.0 ports with data transfer rate up to 3Gb/s (SATA 0 and SATA 1)
• Integrated Advanced Host Controller Interface (AHCI) controller
The Serial ATA connectors are used to connect Serial ATA devices. Connect one end of the Serial
ATA data cable to a SATA connector and the other end to your Serial ATA device.
BIOS Setting
Configure the Serial ATA drives in the Advanced menu (“SATA Configuration” submenu) of the
BIOS. Refer to the chapter 3 for more information.
Features
Note:
SATA port 0 provides adequate space for SATA DOM.
SATA 0
SATA 1 7
RXN
GND
TXP
TXN
GND
1
RXP
GND
SATA 2.0 3Gb/s