DFI BT101 - Manual (Page 21)

www.dfi .com
21
Chapter 2 Hardware Installation
Chapter 2
Rear Panel I/O Ports
The rear panel I/O ports consist of the following:
• 1 12V (BT101) or 19~24V (BT103) DC-in jack or 4-pin power connector* (optional)
• 1 DVI-I port
• 2 RJ45 LAN ports
• 2 USB 2.0 ports
• 1 USB 3.0 port
• Line-out jack
12V DC-in (BT101)/19~24V DC-in (BT103)
DC-in
This jack provides maximum of 100W/120W power and is considered a low power solution.
Connect a DC power cord to this jack. Use a power adapter with 12V (for BT101) or 19~24V
(for BT103) DC output voltage. Using a voltage higher than the recommended one may fail to
boot the system or cause damage to the system board.
The 12V (for BT101) or 19~24V (for BT103) DC-in jack on the system board co-lays with a
4-pin power connector (optional) as the figure displayed below.
USB 2.0
DC-in
DVI-I
USB 3.0
LAN 1 LAN 2 Line-out
DC-in jack
4-pin Power
1 3
2 4
Ground
Ground
+12V
+12V