DFI BL100-NE/-PE - Manual (Page 76)

76
3
BIOS Setup
PnP/PCI Configurations
This section shows how to configure the PCI bus system. It covers
some very technical items and it is strongly recommended that only
experienced users should make any changes to the default settings.
Init Display First
Onboard When the system boots, it will first initialize the
onboard VGA.
PCI Slot When the system boots, it will first initialize PCI.
Reset Configuration Data
Enabled The BIOS will reset the Extended System Configuration
Data (ESCD) once automatically. It will then recreate a
new set of configuration data.
Disabled The BIOS will not reset the configuration data.
The settings on the screen are for reference only. Your version may not be
identical to this one.
Phoenix - AwardBIOS CMOS Setup Utility
PnP/PCI Configurations
Item Help
Menu Level X
Warning: If use PCI VGA
“PEG/Onchip VGA Control”
item must be set to PEG
port.
↑↓→← : Move Enter: Select F1: General Help +/-/PU/PD: Value F10: Save ESC: Exit
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Init Display First
Reset Configuration Data
Resources Controlled By
x IRQ Resources
PCI/VGA Palette Snoop
** PCI Express Relative Items **
Maximum Payload Size
PCI Slot
Disabled
Auto(ESCD)
Press Enter
Disabled
128