DFI BL100-NE/-PE - Manual (Page 35)

35
2
Hardware Installation
Universal Serial Bus Connectors
The system board supports 6 USB 2.0/1.1 ports. USB allows data
exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The USB 6-7 connector allows you to connect 2 additional USB 2.0/
1.1 ports. The USB ports may be mounted on a card-edge bracket.
Install the card-edge bracket to an available slot at the rear of the
system chassis then insert the USB port cable to the USB connector.
BIOS Setting
Configure the onboard USB in the Integrated Peripherals submenu
(“USB Device Setting” section) of the BIOS. Refer to chapter 3 for
more information.
USB 3
USB 2
USB 1
USB 0
USB 6-7
W
W
1
VCC -Data
+Data
GND
Key
VCC -Data +Data GND N.
C
.
2 1 0
9
W