DFI Q7X-151 - Manual (Page 19)

www.dfi .com Chapter 2 Hardware Installation
19
Chapter 2
I/O Connectors
Front Panel Connector
1 2
11 12
HDD-LED
RESET-SW
PWR-LED
ATX-SW
HDD-LED - HDD LED
This LED will light when the hard drive is being accessed.
RESET SW - Reset Switch
This switch allows you to reboot without having to power off the system.
ATX-SW - ATX Power Switch
This switch is used to power on or off the system.
PWR-LED - Power/Standby LED
When the system’s power is on, this LED will light. When the system is in the S1 (POS - Power
On Suspend) state, it will blink every second. When the system is in the S3 (STR - Suspend To
RAM) state, it will blink every 4 seconds.
Pin Pin Assignment Pin Pin Assignment
N.C. 1 N.C.
PWR-LED
2 LED Power
HDD-LED
3 HDD Power 4 LED Power
5 Signal 6 Signal
RESET-SW
7 Ground
ATX-SW
8 Signal
9 RST Signal 10 Ground
N.C. 11 N.C. Key 12 Key