DFI Q7X-151 - Manual (Page 18)

www.dfi .com Chapter 2 Hardware Installation
18
Chapter 2
Wake-On-USB Keyboard/Mouse
The Wake-On-USB Keyboard/Mouse function allows you to use a USB keyboard or USB mouse
to wake up a system from the S3 (STR - Suspend To RAM) state. To use this function:
• Jumper Setting
JP1 (for USB 0-1), JP2 (for USB 2-3) and JP23 (for USB 4-5) must be set to “2-3 On: +5V_
standby”. Refer to “USB Power Select” in this chapter for more information.
Important:
If you are using the Wake-On-USB Keyboard/Mouse function for 2 USB ports, the
+5V_standby power source of your power supply must support ≥1.5A. For 3 or more
USB ports, the +5V_standby power source of your power supply must support ≥2A.
Audio
Rear Audio
The system board is equipped with 3 audio jacks. A jack is a one-hole connecting interface for
inserting a plug.
• Line-in/Surround Jack (Light Blue)
This jack is used to connect any audio devices such as Hi-fi set, CD player, tape player, AM/FM
radio tuner, synthesizer, etc.
• Line-out Jack (Lime)
This jack is used to connect a headphone or external speakers.
• Mic-in/Center+Subwoofer (Pink)
This jack is used to connect to the center and subwoofer speakers of the audio system.
BIOS Setting
Refer to the module’s BIOS for more information.
Line-out
Mic-in/
Center+Subwoofer
Line-in/Surround
Rear Audio