DFI Q7X-151 - Manual (Page 17)

www.dfi .com Chapter 2 Hardware Installation
17
Chapter 2
RJ45 LAN Port
The onboard RJ45 LAN port allows the system board to connect to a local area network by
means of a network hub.
LAN
USB Ports
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The system board is equipped with two onboard USB 3.0 ports (USB 0-1) and two onboard
USB 2.0 type A ports (USB 2-3). The 10-pin connector allows you to connect 2 additional USB
2.0/1.1 ports (USB 4-5). The additional USB port may be mounted on a card-edge bracket.
Install the card-edge bracket to an available slot at the rear of the system chassis and then
insert the USB port cables to a connector.
Driver Installation
You may need to install the proper drivers in your operating system to use the USB device.
Refer to your operating system’s manual or documentation for more information.
USB 0
USB 1
USB 2.0
USB 3
USB 2
USB 3.0
10
VCC -Data +Data GND Ke
y
VCC
-Data +Data
GND N. C.
9 1
2
USB 2.0
USB 4-5