Chapter 4 – DFI CR960-HM76 User Manual

Page 36

www.dfi .com

Chapter 4 BIOS Setup

Chapter 4

CPU Configuration

This section is used to configure the CPU. It will also display the detection of CPU information.

Limit CPUID Maximum

The CPUID instruction of some newer CPUs will return a value greater than 3. The

default is Disabled because this problem does not exist in the Windows series

operating systems. If you are using an operating system other than Windows, this

problem may occur. To avoid this problem, enable this field to limit the return value to

3 or less than 3

Intel Virtualization Technology

When this field is set to Enabled, the VMM can utilize the additional hardware

capabilities provided by the Intel Virtualization technology. A full reset is required to

change the setting.

Disabled for Windows XP.

Advanced



Select Screen



Select Item

Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous

Values

F3: Optimized

Defaults

ESC: Exit

CPU Confi guration

Intel(R) Celeron(R) CPU 827E @1.40GHz
CPU Signature
Microcode Patch
Max CPU Speed
Min CPU Speed
CPU Speed
Processor Cores
Intel HT Technology
Intel VT-X Technology
Intel SMX Technology
64-bit

L1 Data Cache
L1 Code Cache
L2 Cache
L3 Cache

Limit CPUID Maximum

Intel Virtualization Technology

206a7
25
1400 MHz
800 MHz
1400 MHz
1
Not Supported
Supported
Not Supported
Supported

32 KB x 1
32 KB x 1
256 KB x 1
1536 KB

[Disabled]

[Diaabled]

SATA Configuration

This section is used to configure the settings of SATA device.

Enable or disable SATA
Device.

SATA Controller(s)

SATA Mode Selection
SATA Test Mode

Serial ATA Port 0
Software Preserve
Serial ATA Port 1
Software Preserve
Serial ATA Port 2
Software Preserve
Serial ATA Port 3
Software Preserve

Advanced

SATA Controller(s)

This field is used to enable or disable the Serial ATA device.

SATA Mode Selection

The mode selection determines how the SATA controller(s) operates.

IDE Mode

This option configures the Serial ATA drives as Parallel ATA storage devices.

AHCI Mode

This option allows the Serial ATA devices to use AHCI (Advanced Host Controller

Interface).

RAID Mode

This option allows the Serial ATA devices to use RAID 0/1/5/10/Recovery (Redundant

Array of Independent Disks).

SATA Test Mode

This field is used to enable or disable the Serial ATA Test Mode.

[Enabled]

[IDE]
[Disabled]

ST500DM002-1BD (500.1)
SUPPORTED
Empty
Unknown
ATAPI iHOS10 ATAPI
N/A
Empty
Unknown