DFI CR960-HM76 - Manual (Page 31)

www.dfi .com Chapter 3 Hardware Installation
31
Chapter 3
4. While supporting the mounting screw at the bottom, from the top side of the board, fasten
a bolt into the screw.
5. The photo below shows the solder side of the board with the screws already fixed in place.
Bolts
Mounting screw
6. The photo below shows the component side of the board with the bolts already fixed in
place.
7. Position the heat sink on the top of CR960-QM77/HM76 with the heat sink’s mounting
holes aligned with CR960-QM77/HM76 mounting holes. Insert one of the provided long
screws into the mounting hole shown in the photo below.
Bolts
Long screw
Mounting hole