Chapter 3 – DFI CR901-B User Manual
Page 30
![background image](https://www.manualsdir.com/files/781216/content/doc030.png)
www.dfi .com
Chapter 3 Hardware Installation
30
Chapter 3
4. While supporting the mounting screw at the bottom, from the top side of the board, fasten
a bolt into the screw.
5. The photo below shows the solder side of the board with the screws already fixed in place.
Bolts
Mounting screw
6. The photo below shows the component side of the board with the bolts already fixed in
place.
7. Position the heat sink on top of CR901-B with the heat sink’s mounting holes aligned with
CR901-B’s mounting holes. Insert one of the provided long screws into the mounting hole
shown in the photo below.
Bolts
Long screw
Mounting hole
See also other documents in the category DFI Hardware:
- ES300 (2 pages)
- U340 Series (2 pages)
- VS Series (2 pages)
- BT9A3 (57 pages)
- CD9A3 series (60 pages)
- CD905-B series (68 pages)
- BT700 (71 pages)
- BT700 (71 pages)
- CD905-B2600 (63 pages)
- CD905-B2800 (63 pages)
- CP908-B (104 pages)
- CR908-B (68 pages)
- HR908-B (66 pages)
- HU968 (86 pages)
- ML905-B11C/B16C (76 pages)
- KB968 (68 pages)
- LR905-B18S (93 pages)
- OT905-B series (61 pages)
- CM960-B (1 page)
- CM901-B (72 pages)
- CP900-B (130 pages)
- NP905-B16C (125 pages)
- CR900-B (73 pages)
- CR902-BL (75 pages)
- CR960-QM77 (81 pages)
- HM920-QM87 (98 pages)
- G5C900-B106 (118 pages)
- HM960-QM87 (101 pages)
- HM961-QM87 (95 pages)
- HR900-B (102 pages)
- HR902-BL (75 pages)
- FS700 (17 pages)
- QB702-B (47 pages)
- QB700-B (73 pages)
- COM100-B (32 pages)
- QB701-B (73 pages)
- NP900-B16C (121 pages)
- COM101-BAT (32 pages)
- COM630-B (50 pages)
- COM330-B (57 pages)
- Q7-100 (31 pages)
- Q7-951 (46 pages)
- Q7A-551 (23 pages)
- Q7X-151 (30 pages)