DFI CR902-B - Manual (Page 38)

www.dfi .com Chapter 4 BIOS Setup
38
Chapter 4
CPU PPM Configuration
EIST
This field is used to enable or disable the Intel Enhanced SpeedStep Technology.
Turbo Mode
The options are Enabled and Disabled.
CPU C3 Report
Enabled/Disabled CPU C3 (ACPI C2) report to OS.
CPU C6 Report
Enabled/Disabled CPU C6 (ACPI C3) report to OS.
Enable/Disable Intel
SpeedStep
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1227. Copyright (C) 2012 American Megatrends, Inc.
CPU PPM Confi guration
EIST
Turbo Mode
CPU C3 Report
CPU C6 Report
Advanced
[Enabled]
[Enabled]
[Enabled]
[Enabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save and Reset
ESC: Exit
Network Stack
Enable or disable UEFI
network stack.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1227. Copyright (C) 2012 American Megatrends, Inc.
Network Stack
Advanced
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save and Reset
ESC: Exit
Network Stack
This field is used to enable or disable the UEFI network stack, when enabled, Ipv4 PXE
Support and Ipv6 PXE Support are available to setup.
Enable or disable UEFI
network stack.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1227. Copyright (C) 2012 American Megatrends, Inc.
Network Stack
Ipv4 PXE Support
Ipv6 PXE Support
Advanced
[Enabled]
[Enabled]
[Enabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save and Reset
ESC: Exit
Ipv4 PXE Support
Enabled Ipv4 PXE Boot Support. If disabled Ipv4 PXE Boot option will not be created.
Ipv6 PXE Support
Enabled Ipv6 PXE Boot Support. If disabled Ipv4 PXE Boot option will not be created.