Chapter 4 – DFI CR902-B User Manual

Page 35

www.dfi .com

Chapter 4 BIOS Setup

Chapter 4

SATA Configuration

This section is used to configure SATA functions.

Enable or disable SATA
Device.

SATA Controller(s)

SATA Mode Selection

Serial ATA Port 0
Software Preserve
Serial ATA Port 1
Software Preserve
Serial ATA Port 2
Software Preserve
Serial ATA Port 3
Software Preserve

Advanced

SATA Controller(s)

This field is used to enable or disable the Serial ATA channels.

SATA Mode Selection

IDE Mode

This option configures the Serial ATA drives as Parallel ATA storage devices.

AHCI Mode

This option allows the Serial ATA devices to use AHCI (Advanced Host Controller Inter-

face).

RAID Mode (CR902-B Series only)

This option allows the Serial ATA devices to use RAID 0/1/5/10/Recovery (Redundant

Array of Independent Disks)

[Enabled]

[IDE]

ST3160812AS (160.0GB)
Supported
ATAPI iHAS32 ATAPI
N/A
Empty
Unknown
Empty
Unknown



Select Screen



Select Item

Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous

Values

F3: Optimized

Defaults

F4: Save and Reset
ESC: Exit

If AHCI or RAID(CR902-B only) is selected in the SATA Mode Selection, it will display the fol-

lowing information:

Determines how SATA
controller(s) operate.

SATA Controller(s)

SATA Mode Selection

Serial ATA Port 0
Software Preserve

Port 0

Hot Plug
SATA Device Type

Serial ATA Port 1
Software Preserve

Port 1
Hot Plug
SATA Device Type

Serial ATA Port 2

Software Preserve

Port 2

Hot Plug

Serial ATA Port 3
Software Preserve

Port 3

Hot Plug

Advanced

Serial ATA Port 0 to Serial ATA Port 3

These fields are used to configure the connected SATA devices.

[Enabled]

[AHCI]

ST3160812AS (160.0GB)
Supported

[Enabled]
[Disabled]
[Hard Disk Driver]

ATAPI iHAS32 ATAPI
N/A