DFI CR902-B - Manual (Page 14)

www.dfi .com Chapter 3 Hardware Installation
14
Chapter 3
Connectors
CPU Fan Connector
Connect the CPU fan’s cable connector to the CPU fan connector on the board. The cooling fan
will provide adequate airflow throughout the chassis to prevent overheating the CPU and board
components.
BIOS Setting
“Module Board H/W Monitor” submenu in the Advanced menu of the BIOS will display the cur-
rent speed of the cooling fan. Refer to chapter 3 of the manual for more information .
3
1 Sense
Power
Ground
COM Express Connectors
The COM Express connectors are used to interface the CR902-B/BL Series COM Express board
to a carrier board. Connect the COM Express connectors (lcoated on the solder side of the
board) to the COM Express connectors on the carrier board.
Refer to the “Installing CR902-B/BL Series onto a Carrier Board” section for more information.
COM Express Connectors
Refer to the following pages for the pin functions of these connectors.