DFI CR900-B - Manual (Page 39)

www.dfi .com Chapter 4 BIOS Setup
39
Chapter 4
Device reset time-out
Selects the USB mass storage device start unit command timeout.
Device power-up delay
Maximum time the device will take before it properly reports itself to the Host Controller.
“Auto” uses default value: for a Root port it is 100 ms, for a Hub port the delay is taken
from Hub descriptor.
Onboard ATA Controller Configuration
This section is used to Enables or disables the onboard ATA controller.
Select an operative mode
for ATA controller.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
SATA Port 0
SATA Port 1
ATA Controller
Advanced
Not Present
Not Present
[IDE Mode]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit
ATA Controller
Selects the ATA controller’s mode.
CPU PPM Configuration
EIST
This field is used to enable or disable the Intel Enhanced SpeedStep Technology.
Turbo Mode
The options are Enabled and Disabled.
Enable/Disable Intel
SpeedStep
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
CPU PPM Confi guration
EIST
Turbo Mode
Advanced
[Enabled]
[Enabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit