DFI HU968 - Manual (Page 12)

www.dfi .com Chapter 3 Hardware Installation
12
Chapter 3
System Memory
Standby
Power LED
The system board is equipped with 2GB/4GB/8GB DDR3L system memory onboard supporting
1600MHz, dual channel memory interface.
DDR3L
Important:
Electrostatic discharge (ESD) can damage your board, processor, disk drives, add-in
boards, and other components. Perform installation procedures at an ESD workstation
only. If such a station is not available, you can provide some ESD protection by wear-
ing an antistatic wrist strap and attaching it to a metal part of the system chassis. If
a wrist strap is unavailable, establish and maintain contact with the system chassis
throughout any procedures requiring ESD protection.
Important:
When the Standby Power LED lit red, it indicates that there is power on the board.
Power-off the PC then unplug the power cord prior to installing any devices. Failure to
do so will cause severe damage to the board and components.
System Memory
DDR3L
DDR3L
DDR3L
DDR3L
DDR3L
DDR3L
DDR3L
Top View
Bottom View