DFI ST101-CP - Manual (Page 3)

3/9
1. Position the SATA drive at the
bottom side of the drive bay
bracket.
2. To secure SATA to the drive bay
bracket, you must fasten screws
from the top side of the drive
bay bracket.
While holding the SATA drive in
place, turn the drive bay bracket
to the top side then adjust the
drive so that the mounting holes
on the drive match the mounting
holes on the bracket. Now secure
the drive by fastening 4 screws.
Screw
Installing the SATA and Optical Drives
Screw
SATA power
connector
SATA data
connector
Rear view of the SATA drive