Devolo LAN Audio extender - Manual (Page 32)

Appendix
|
| devolo dLAN Audio extender |
32
Sound output cannot be switched
Effect:
The sound output is not carried out via the dLAN Audio extender, but is still
switched via the loudspeakers directly connected to the PC.
Possible causes:
b
The sound card driver is not correctly installed.
b The sound output has not been redirected to the devolo dLAN Audio
extender.
b
The switch to the adapter did not occur until after the start of the sound
application.
Solutions:
b Please install the driver and the software for the adapter.
b
Switch the sound output with the help of the dLAN Audio extender software
before starting the audio program.
Sound too low
Effect:
The sound of your stereo system or at the active loudspeakers is very low.
Possible causes:
b
The sound at the stereo system or at the active loudspeakers is set to low or
muted.
b
The sound output on your PC is set to low (e.g. in the Windows volume con-
trol).
b You are using passive loudspeakers without amplifier for audio playback.
Solutions:
b Turn the sound volume higher at the output device. If the sound quality
should decrease now, see also the following item.
b
In Windows XP, call up the volume control via start ! Control Panel !
Sounds and Audio Devices ! Volume ! Device volume ! Advanced.
Move the Volume and Wave controls completely up. Next, use only the vol-
ume control of your stereo system or your active loudspeakers to adjust the
sound output up or down.