Devolo LAN Audio extender - Manual (Page 31)

|
Appendix 31
| devolo dLAN Audio extender |
5.1.2 Audio playback
No sound output
Effect:
No sound.
Possible causes:
b
The volume of your stereo system or active loudspeakers is turned down or
muted.
b
The audio cable is not plugged in or slipped out.
b The audio cable is connected to a different input or an output of your stereo
system or active loudspeakers.
b
The sound of your computer is turned down or muted, e.g. in the Windows
volume control.
b
The sound output was not switched to the dLAN Audio extender, but is still
switched via the PC sound card.
b The dLAN is not correctly configured.
b
The transmission speed in the dLAN is too slow.
Solutions:
b
Turn the volume higher at the output device or switch muting off.
b Check whether the audio cable is plugged into the correct sockets at both
ends.
b
In Windows XP, call up the volume control via start ! Control Panel !
Sounds and Audio Devices ! Volume ! Device volume ! Advanced.
Ensure that both Volume Control and Wave are not turned all the way
down and that the Mute check boxes of these two channels are not dis-
abled.
b Check whether the devolo dLAN Audio extender Control software is
loaded (identified by an icon consisting of a note with a loudspeaker in the
Windows system tray at the bottom right on the taskbar) and the output is
redirected to the devolo Audio extender sound driver (right-click on the
application icon, then Select default audio device).
b
Check whether your dLAN functions properly.