Devolo dLAN 200 AV Wireless G - Manual (Page 24)

Configuration
|
|
devolo dLAN 200 AV Wireless G
|
24
Prompt. Enter the command IPCONFIG /ALL. The MAC is shown under the des-
ignation Physical Address.
Do not forget to click Save after entering the MAC addresses. An error message
will be returned if any of the values entered are invalid (e.g. because the colons
are missing).
Please remember to enter the MAC address of your own computer as well if you
are connected to the dLAN 200 AV Wireless G via WLAN rather than the Ether-
net port. Otherwise, you will lock yourself out of the device via WLAN by acti-
vating the WLAN filter!
3.4.5 dLAN settings
In a dLAN network, all connected components must use the same password. The
dLAN password is usually defined once during installation of your
dLAN 200 AV Wireless G by using the dLAN Configuration Wizard or the
encryption button (see chapter 4 'Establishing a connection to the dLAN net-
work') or carried over from the existing network.
Click on the Go to devolo home page link to access our website.