Devolo dLAN 200 AV Wireless G - Manual (Page 13)

|
Initial use 13
|
devolo dLAN 200 AV Wireless G
|
ብ Press the WLAN button to switch the WLAN function of your device on or
off.
ቦ The device is connected to the mains power supply via the power supply
jack.
The WLAN antennas provide the connection to other wireless network devices.
You can angle the antennas to adjust the transmission and reception power
appropriately according to the installation location.
Note that the WLAN function is enabled and WLAN encryption is disabled
when the device is set to its factory defaults.
2.3 Connecting the dLAN 200 AV Wireless G
Firmware note: If you would like to use a dLAN 200 AV Wireless G together
with devolo
dLAN 200 AV devices using firmware version 1.x, please update the
firmware of the dLAN 200 AV devices first. The firmware updater application can
be found in the download section of our website at www.devolo.com.
ቢ Connect the dLAN 200 AV Wireless G to your computer or other network
devices using a network cable.
ባ Plug the dLAN 200 AV Wireless G into a free electrical outlet. Ensure that
the device is fully inserted in the outlet.
If possible, do not plug the adapter into a power strip. This may impair the trans-
mission of the dLAN signals. A free wall outlet is preferable.
2.4 Software installation
2.4.1 Software for Windows
Use the installation wizard to set up the following software components for
using the device with the Windows operating system:
b The devolo dLAN Configuration Wizard lets you set up custom encryption
for your dLAN 200 AV network.
b devolo Informer finds dLAN devices in a dLAN network and displays infor-
mation on the devices found.
b
The dLAN 200 AV Wireless G configuration application starts the inte-
grated configuration interface of your dLAN 200 AV Wireless G.