Devolo dLAN 1200+ WiFi ac - Manual (Page 13)

12 Introduction
devolo dLAN 1200+ WiFi ac
b The LED lights up white if the
dLAN 1200+ WiFi ac is ready to operate and a
dLAN connection exists.
b The LED flashes white quickly at regular inter-
vals if the encryption process (pairing) is being
performed in the dLAN network.
b The LED flashes white at irregular intervals if
the dLAN 1200+ WiFi ac is in PowerSave
mode.
b The LED flashes red at regular intervals if the
transmission rate of the dLAN 1200+ WiFi ac is
not in the optimum range. For information on
improving the transmission rate, refer to Chapter
6.1 Bandwidth optimization.
WiFi Move Technology
WiFi Move Technology is a function for synchronising
the WiFi settings of all WiFi adapters. Activate the syn-
chronisation either using the functions on the configu-
ration interface (see Chapter 5.3.6 WiFi Move) or at
the touch of a button on the adapter.
ቢ First press the encryption button with the home
icon (for about 1 second) on an existing
dLAN 1200+ WiFi ac that has the entire WiFi
configuration which is to be transferred to all
other dLAN 1200+ WiFi ac adapters. Then,
within 2 minutes, press each encryption button
on the new dLAN 1200+ WiFi ac devices (for
about 1 second).
ባ The WiFi adapters are now continuously con-
nected to each other and, from now on, share
changes to the WiFi configuration with each
other automatically.
2.3.2 WiFi button
The WiFi button controls the following WiFi
functions:
WiFi On/Off:
b
In the factory default settings, the WiFi set-
ting is already enabled and the WiFi encryption is
set to WPA2. The default WiFi key for the initial
installation of the dLAN 1200+ WiFi ac is the
adapter's WiFi key. You will find the unique key on
the label on the back of the housing.
Fig. 3