Datatek IPv6 Transformer Quick Start Guide - Manual (Page 13)

IPv4-IPv6 Transformer Quick Start Guide
www.datatekcorp.com
7. Reboot
The configuration changes we made on the System: Interface Setup page require you
to reboot the Transformer for the changes to take effect. Reboots are only required
during the initial configuration of the Transformer. Routine configuration changes, such
as those you would make on the System: Static address map page, don’t require
reboots.
Select the Diagnostics link. This will reveal a set of links that are normally hidden.
Select the Diagnostics: Reboot system link. Select Reboot, and when asked if you
are sure, select Yes. It takes about one minute for the Transformer to reboot.
Figure 7-1