Dataprobe iPIO-8 Quick Start - Manual (Page 2)

iPIO-8 Quick Start Guide
Page 2
Ref: ipio8_1.20_qs ver: 2011-08-25
Power supply
The iPIO-8 is provided with a wall mounted power supply, item
1930075. This power supply is provided with four plug styles to
accommodate most locations. The plug for North America is pre
installed.
Network
Connect the network to the iPIO-8 with the Cat 5 cable, provided,
or suitable replacement. The Network connector on the iPIO-8
has two LED indicators. The orange LINK LED indicates a
successful connection to the network. The Green Activity (Act)
LED blinks to display network activity.
During power up sequence, Act LED will be solid on until boot process is complete. After boot, Act LED
blinking indicates network activity. Boot up takes about 20 seconds.
WEB Page Access
The web pages provide status information on the
inputs and outputs of the iPIO-8, as well as provide
configuration for the unit. Open a browser to the
default or current IP address of the unit. Enter the
default username and password:
Factory Defaults:
Version 1.2
IP Address 192.168.1.254
Version 1.1
IP Address 192.168.0.254
User Credentials
User Type Default Username / Password Access
Administrator admin / admin View, Control and setup
General User user / user View and Control
Recover IP Address and Set Factory Defaults
Dataprobe provides a Setup Utility that
1) Discovers iPIO-8 units on the local network, and displays the current IP Address
2) Allows setting the IP Address
3) Resets to Factory Defaults
Download the Setup Utility from Dataprobe website at
http://dataprobe.com/ipio-web-relay-control.html?Resources
iPIO-8 Login Page
Power Supply 1930075 Included