Daktronics BA-515 - Manual (Page 27)

Mechanical Installation 6-5
6.4 Ad Panel Mounting
Reference Drawings:
Ad Panel Mounting.................................................................................. Drawing A-52187
Assembly, Ad Panel, BA-515 .................................................................. Drawing A-52585
Ad Panel Mounting, BA-518.................................................................... Drawing A-52811
Refer to Drawing A-52187 for mounting details.
Mount the ad panel(s) as follows:
1. Use the mounting channel to determine which hole combination to use. Be sure to keep the
bolts as close to the beam as possible.
2. Using the mounting channel as a template, drill 9 /
16
" holes in the upper and lower rear flange
of the ad panel where the supports will go.
3. Place square nuts inside the channel and thread the bolts through.
4. Lift the ad panel into position with the bolts still in place.
5. Place mounting angles over each pair of bolts and secure with lock washers and hex nuts.
6. When the panel is adjusted to the final desired position, tighten hex nuts firmly.
When mounting ad panels with back sheets, remove the back sheets in the areas above and below
the holes drilled in the upper and lower rear flange of the ad panel. Be sure to replace the back
sheets after placing the square nuts inside the channel and threading the bolts through the holes.
Models BA-515 and BA-518
Ad panels are mounted directly to the scoreboard for models BA-515 and BA-518. Refer to
Drawings A-52585 and A-52811 for mounting details.