Daktronics Configuring the DM-100 Gen III for Gilbarco G-Site/Passport Interface - Manual (Page 6)

Configuring the DM-100 Gen III for Gilbarco
G-Site/Passport Interface Quick Guide Page 6 of 7
DD2294804 Rev 02
13 February 2014 PO Box 5128 201 Daktronics Drive, Brookings, SD 57006-5128
tel: 800-325-8766 fax: 605-697-4700
www.daktronics.com
When AUTOMATIC dimming is selected, the following LCD prompt appears:
The following LCD prompt is shown for both MANUAL and AUTOMATIC dimming selections:
Set Petroleum Prices
Each line automatically updates when the price is changed in the PoS system. The following error appears when
you attempt to edit prices that are configured for PoS control:
Update the Display
1. After connecting to the display with the handheld controller, press UPDATE DISPLAY to show the new
sequence on the display.
2. This button also allows for a preview of the new sequence on the LCD.
Multi-Pylon Troubleshooting Steps
Complete the following steps – that may correct communication errors – before calling for service/support:
1. Locate the breaker panel for each pylon.
2. Power down each pylon (in no particular order).
3. Power down control equipment.
4. Verify all equipment is turned off.
LCD Screen Action
SET AUTO DIMMING
MAX INTENSITY?
Press the ENTER/EDIT key to edit the maximum intensity that the
display uses in full-bright modes (during daylight hours).
Press CLEAR to keep the current auto dimming maximum setting.
LCD Screen Action
INTENSITY XX ↑↓
ENTER TO SET
XX – Current intensity (2-64)
Max Intensity – 64
Press the Up and Down Arrow keys to modify the display’s current
intensity. ( Note: The RC-100 must be communicating with the display)
Press ENTER to accept this intensity.
When manual dimming mode is selected, this is the display’s new
intensity.
When automatic dimming mode is selected, the display illuminates in
full-bright mode, which is the maximum intensity level.
LCD Screen Action
THIS PRICE POS
CTRLD. OVERRIDE?
To manually edit the price, press ENTER.
To cancel, press CLEAR.