Daktronics Tuff Sport Indoor LED Scoreboards - Manual (Page 18)

12 Scoreboard Troubleshooting
2.5 Radio Connections
To determine the settings for radio connections between the scoreboard and control console:
1. Power off any radio-equipped consoles in the area.
2. Cycle power to the scoreboard, and watch for the radio settings. These settings
appear in different locations based on the scoreboard layout:
 When using the All Sport 5000
controller, the scoreboard will
display “bX CY” where X is the
Broadcast group number and Y is
the Channel number. The default is
b1C1.
o
If there is a clock, the settings
appear in the first four clock
digits (Figure 11).
o If there is no clock, the settings
should appear in the Home and
Guest score digits, but this may
vary by scoreboard model.
 When using the RC-100 controller,
the scoreboard will display “CXX”,
where the XX is a channel from 01-
15 (Figure 12). The default is
channel 01.
Note: If these settings do not appear, the radio receiver may need to be
repaired/replaced.
To make sure the console radio settings match the receiver in the scoreboard, refer to the
appropriate
control console manual .
All Sport Radio Settings RC-100 Radio Settings
Radio Interference
If it has been determined that a nearby scoreboard’s radio signal is interfering, the settings of
the radio receiver or wireless base station inside the scoreboard(s) must be changed.
1. To locate the radio receiver or base station, simply look for the black antenna sticking
out the front of the scoreboard. Component location drawings also show the exact
position where the radio receiver will be mounted.
2. Open the access panel to which the receiver is attached as described in Section 2.2.
The channel selection process varies depending on whether the scoreboard is equipped with
or a radio receiver (All Sport 5000) or a wireless base station (RC-100).
Figure 11: All Sport Radio Settings (Clock)
Figure 12: RC-100 Radio Settings (Clock)
RADI O SETTI NGS
BCAST 1 CHAN 01 RADI O CHANNEL
DEFAULT: 01