Daktronics PC-2002 Pace Clock System - Manual (Page 9)

Mechanical Installation 3
Section 2:
Mechanical Installation
This section describes the mounting details of the PC-2002. Use this section when mounting a display
to a wall surface or into a hole in the wall. Other mounting methods can be used, but Daktronics
engineers do not recommend those not documented here. Daktronics is not responsible for mounting
the display. The customer is responsible for providing mounting anchors/screws. A qualified
engineer must specify the mounting anchor type according to national and local building codes.
Note: Daktronics does not assume any liability for any installation derived from the information
provided in this manual or installations designed and installed by others.
2.1 Surface Mounting
The PC-2002 can mount directly to the wall surface using top and bottom mounting brackets.
These brackets then attach to the wall with four anchors. Refer to Figure 4:
wall anchors
(not provided)
9.70"
Front view Side view
12.00"
9.70"
with surface mounting brackets
Figure 4: Surface Mounting Installation
3/16" – 1/4" anchors
(not provided)
Side View
Front View
12.0"
9.7" 9.7"