Daktronics PC-2002 Pace Clock System - Manual (Page 11)

Electrical Installation 5
Section 3:
Electrical Installation
Note: Verify that all power is disconnected before working with electrical components; severe injury
or damage to components could occur if the display is serviced while powered.
3.1 Power
The PC-2002 receives external power through a standard 3-prong power cord plugged into a
120 VAC outlet. Figure 6 displays the dimensions for placing the signal J-box and power
outlet to line up with the openings in the back of the display for the surface mount option.
Figure 7 displays the dimensions for placing the signal J-box and power outlet in order to line
up with the openings in the back of the display for the flush mount option.
Front view
Recess in the
back of the display
Wall
PC-2002
Wall cutout outline
4.0"
min.
Side view
2.5"
120V AC receptacle
Signal wiring box
25.5"
8.0"
5.0"
Side view
9.70"
1"
min.
Wall
Front view
Power connection may be set up with the receptacle mounted near
the PC-2002 display, or recessed into the wall behind the display.
12.00"
recessed receptacle
Figure 6: Surface Mounting Electrical Installation
Figure 7: Flush Mounting Electrical Installation
Front View
Side View
Recessed receptacle
Wall
Power connection may be set up with the receptacle
mounted near the PC-2002 display, or recessed into
the wall behind the display.
Front View
Hole Outline
Signal J-box
120 VAC
Side View
Wall
PC-2002
Recess on
display rear
9.7"
12.0"
1"
min.
25.5"
8.0"
5.0"
4.0"
2.5"
4.0"
min.