Daktronics PC-2002 Pace Clock System - Manual (Page 10)

4 Mechanical Installation
Attach the brackets to the top and bottom of the display. Level the display against the
mounting surface and make a mark through the anchor holes on the bracket with a marker or
heavy pencil. Drill holes in the wall and install anchors at the marked locations. Minimum
steel anchor size is 3/16" diameter (4.7 mm).
2.2 Flush Mounting
The PC-2002 can be flush mounted into a 25.5" x 10.0" hole in the wall using a mounting
bezel. This bezel then attaches to the wall with 6 anchors. Attach the bezel around the display
with 8 screws. Provide power and signal wiring inside the opening and then connect the
power and signal to the display (see Section 3). Drill holes in the wall and install anchors at
the holes in the bezel. Refer to Figure 5:
10.00"
25.50"
Wall anchors and
mounting screws
are not provided
Flush mounting bezel
Wall opening
Figure 5: Flush Mounting Installation
Wall anchors/screws
are not provided
Wall opening
Flush mounting bezel
25.5"
10.0"