Daktronics PC-2002 Pace Clock System - Manual (Page 19)

Display Maintenance 13
Section 5:
Display Maintenance
IMPORTANT NOTES :
1. Disconnect power before doing any repair work on the scoreboard.
2. Allow only qualified service personnel access to internal display electronics.
3. Disconnect power when not using the scoreboard.
5.1 Digit/Driver Printed Circuit Board
The PC-2002 uses a single printed circuit board (PCB) that contains all of the electronics
needed to make this system work: digit LEDs, control processors, power input connectors,
horn, and other components. All switches, power systems, and input/output terminations are
connected to the PCB.
As shown in Figure 8, the PCB is attached to the front panel of the display. Refer to Section
‎
5.2 for instructions on accessing and replacing the PCB.
Screw
(HC-1489)
Case
Back
Circuit Board
Part number varies
with model number
Case
Front
Spacer
(HE-1357)
6-32 Nut
(HS-1354)
Transformer
(T-1082)
Figure 8: PC-2002 Exploded View
Rear Panel
Front Panel
Spacer
(HE-1357)
Screw
(HC-1489)
8-32 Nut
(HC-1354)
Printed Circuit Board
(Indoor: 0P-1153-0005)
Transformer
(T-1082)