Daktronics SW-2101 Aquatics/Track LED Scoreboard - Manual (Page 16)

10 Electrical Installation
Connect the appropriate wires coming through the rear of the scoreboard to the load center
terminals, as described below and shown in Figure 5.
 live wire (black) to LINE 1
 neutral (white) wire to NEUT.
 ground wire (green/yellow) to the grounding buss bar
3.3 Indoor Signal Connection
1. Route signal cable in conduit from the scoreboard location to a signal junction box
(J-box) or wall plate near the control location. At a minimum, use paired, 22 AWG
shielded cable (part # W-1077).
2. Connect a 1 /
4
" phone plug (part # 0L-40683) to the signal cable at the scoreboard
location, and insert the plug into the SIGNAL IN jack on the left side of the scoreboard.
Note: Refer to Section 3.1 if the signal jack is not already installed.
3. Connect a signal cable from the 1 /
4
" J-box or wall plate to the J2 or J3 jack on the
OmniSport 2000 console.
Figure 5: Load Center Power Connections (Cover Removed)