Daktronics SW-2101 Aquatics/Track LED Scoreboard - Manual (Page 11)

Mechanical Installation 5
Horizontal Wall Mounting (Indoor Only)
Reference Drawings:
Strut Spacing, Horizontal Wall Mounting ......................................... Drawing A-129905
End Bracket Attachment, Horizontal Wall Mounting ........................ Drawing A-129906
Horizontal Wall Mounting, Final Steps ............................................. Drawing A-129907
Use this method when the overall display has modules mounted side by side.
1. Before attaching the digit module to the wall, attach the caption module to the digit
module as described in Section 2.1.
Note: Extra strut length is not required when caption modules are mounted at either
top or bottom of the column.
2. Attach mounting struts to the wall. Strut length will vary depending on the total
number of display modules. Refer to Drawing A-129905 to determine strut length
and the center-to-center distance between the struts.
3. Attach the end brackets to the right end of all the modules in the left column.
Next, attach brackets to the left end of all the modules in the right column (refer to
Drawing A-129906).
4. Use 3 /
8
" bolts to attach the modules in the left column to spring nuts in the struts
(Figure 4). Mount the lowest module first, and then add modules working upward.
5. Starting with the bottom-right module, insert the screw heads on the end brackets of
the left side of the cabinet into the keyholes on the mating bracket of the right side of
the left column cabinet, and press down on the right side until both cabinets are flush
and level horizontally (refer to Drawing A-129907).
6. Once the right column cabinet is joined to the left column cabinet, use 3 /
8
" bolts to
attach the right end of the right column module to spring nuts in the struts (Figure 4).
7. Repeat steps 5 and 6 for all remaining right column modules, working upward.
Corner-Mounting (Indoor Only)
Reference Drawing:
Corner Mount ................................................................................... Drawing A-130508
If the display is to be mounted across the corner of adjoining walls, corner-mounting brackets
may be ordered as an option. Drawing A-130508 details this type of mounting.
Multi-line display models that use a single vertical arrangement of modules may be mounted
with corner brackets. However, horizontal display configurations cannot be mounted across a
corner using the simple brackets. Such displays must be attached to a structure or framework
that spans across the corner and safely supports the entire display. This type of mounting
must be designed by a qualified engineer.