Daktronics TI-2031 4-Inch LED Bar-Digit Locker Room Clock - Manual (Page 9)

Mechanical & Electrical Installation 3
Section 2: Mechanical & Electrical Installation
The TI-2031 and TI-3031 locker room clocks are equipped with 4" (102 mm) red LED digits. The displays
are connected to the signal from the main scoreboard in the facility and will display the same time that is
shown on the scoreboard.
There are two primary methods of installing these locker room clocks: 1) surface mounted on the wall
with mounting screws or anchors, or 2) flush mounted in the wall between standard spaced 16" studs.
Reference Drawing:
Installation DWG; TI-2031/3031 Locker Room Clock .......................... Drawing B-1064515
2.1 Surface Mount Method
The surface mount cabinet mounts centered over an electrical outlet and uses the deep rear
mounting panel.
1. Drill holes in the wall and install anchors or screws at the locations shown in Drawing
B-1064515. The customer is responsible for providing mounting anchors or screws.
2. Install a 120 V AC, 15 amp electrical outlet or use an existing outlet that is located where
the display will be installed. The outlet should be positioned behind the clock cabinet so
that the wall pack transformer fits in the recessed area of the rear mounting panel.
3. Mount the rear panel on anchor screws and tighten snuggly.
4. Route the signal cable to the clock mounting location and allow it to extend at least 12"
(305 mm) beyond the wall.
5. Connect the signal wire to plug P-1388 signal terminal on the left side of the display
(when viewed from the rear). Connect the red signal wire to the positive (+) jack labeled
“CL-IN” and the white signal wire to the negative (-) jack labeled “CL-IN”.
6. Plug the wall pack transformer into the power jack located below the signal terminal, and
plug the wall pack into the electrical outlet.
7. Line up and mate the rear and front cabinet pieces. Attach the pieces together with
included screws.