Daktronics TI-2031 4-Inch LED Bar-Digit Locker Room Clock - Manual (Page 7)

Introduction 1
Section 1: Introduction
This manual explains the installation, maintenance, and troubleshooting of the TI-2031 and TI-3031
locker room clocks. For additional information regarding the safety, installation, operation, or service
of this system, refer to the telephone numbers listed in Section 4. This manual is not specific to a
particular installation.
Important Safeguards:
 Please read and understand all instructions before beginning the installation process.
 Do not drop control equipment or allow it to get wet.
 Do not disassemble control equipment or electronic controls of the display; failure to
follow this safeguard will make the warranty null and void.
 Disconnect display power when not in use or when servicing.
 Disconnect display power before servicing power supplies to avoid electrical shock.
Power supplies run on high voltage and may cause physical injury if touched while
powered.
 Do not modify the scoreboard structure or attach any panels or coverings to the
scoreboard without the express written consent of Daktronics, Inc.
Project-specific information takes precedence over any other general information found in
this manual.
1.1 Resources
Figure 1 illustrates a Daktronics drawing
label. The drawing number is located in the
lower-right corner of a drawing. This
manual refers to drawings by listing the last
set of digits and the letter preceding them.
In the example, the drawing would be
referred to as Drawing C-325405.
Reference Drawing:
System Riser Diagram ........................................................................... Drawing C-325405
Daktronics identifies manuals by the DD or ED number located on the cover page of each
manual. For example, this manual would be referred to as DD1732287.
The serial and model numbers of a Daktronics scoreboard can be found on the ID label on the
display as shown in Figure 2. Please list the model number, display serial number, and the
date this display became operational in the blanks provided on the second page of this
manual. When calling Daktronics customer service, please have this information available to
ensure the request is serviced as quickly as possible.
Figure 1: Daktronics Drawing Label