CREATOR CROSS Series - Manual (Page 50)

CREATOR CHINA 2013-08 WWW.CREATOR1997.COM
44 CROSS series mixed matrix switch User 's Manual CROSS Series Mixed Matrix Switcher User 's Manual
ASCII
Instructions
(Computer to
the matrix)
Command functions
Return(matrix to
computer)
For example
(00<=xx<=99)
xxC23.
Adjust the parameters of saturation
(00<=xx<=99)
Command OK! xxC23.
xxC24. Adjust the phase parameter (00<=xx<=99) Command OK! xxC24.
xxC25. Adjust the clock parameters (00<=xx<=99) Command OK! xxC25.
xxC26.
Adjust the horizontal position parameter
(00<=xx<=99)
Command OK! xxC26.
xxC27.
Adjust the vertical position parameter
(00<=xx<=99)
Command OK! xxC27.
COMP8 card commands - query recovery operation instruction
01C30.
Query the input channel corresponding to
the current video output
Video Source:xx 01C30.
06C30. Query the current active port resolution RESOLUTION:xx 06C30.
09C30.
Restore the current active port to factory
settings
Command OK! 09C30.
Network default parameters
Matrix port:5000
Matrix IP:192.168.0.2
Matrix gateway:192.168.0.1
Matrix subnet mask:255.255.255.0
Matrix hardware address:0x00.0x11.0x22.0x33.0x44.0x55;
Note: The network parameters come into effect only after restarting the matrix system.
1.RS-232 and IR panel operation are forward (forward: input connect RS-232 or IR sender, output
connect RS-232 or IR receiver);
2.RS-232 and IR reverse switch to toggle through the machine's serial instruction (reverse: input
connected to RS-232 or IR receiver, output connected to the RS-232 or infrared sender) please View
serial instructions for serial switcher instruction.
3.NO matter forward or reverse switch of infrared and serial signal, one way can be switched to another
or more ways, multiple ways cannot be switched at the same time to one way.