CREATOR CROSS Series - Manual (Page 48)

CREATOR CHINA 2013-08 WWW.CREATOR1997.COM
42 CROSS series mixed matrix switch User 's Manual CROSS Series Mixed Matrix Switcher User 's Manual
ASCII
Instructions
(Computer to
the matrix)
Command functions
Return(matrix to
computer)
For example
1D1,2,3,4,5,6,7,8.) As input ports [Xn] are
required in the same layer of the input
card, so only 8 roads can be written at one
time (for example: 1D1,2,3,4,5,6,7,8.)
COMP8 input and output card control instruction table
ASCII
Instructions
(Computer to
the matrix)
Command functions
Return(matrix to
computer)
For example
COMP8 card commands - set active command to card port
(Note: Activate the card port before the corresponding port parameter settings)
[X1],[X2],…,[Xn]
SETIN.
Enter the input card debugging mode,
activate the port of COMP8 input card (the
maximum number is up to 40) and it will
automatically exit debugging mode without
any operation in 10 minutes.
Note: Only one input port can be activated
during query; output card debugging mode
automatically exit after the use of the
command, and the port activated by input
card debugging mode automatically become
invalid .
Command OK!
1,2,3,4SETI
N.
[Y1],[Y2],…,[Yn]
SETOUT.
Enter the output card debugging mode,
activate the port of COMP8 output card (the
maximum number is up to 40) and it will
automatically exit debugging mode without
any operation in 10 minutes.
Note: Only one output port can be activated
during query; input card debugging mode
automatically exit after the use of the
command, and the port activated by output
card debugging mode automatically become
invalid .
Command OK!
1,2,3,4SETO
UT.
EXITSET. Exit component card debugging mode state Command OK! EXITSET.
COMP8 card commands - video switching operation instruction
01C02. Set the active port to CV video mode Command OK! 01C02.
03C02. Set the active port to YPbPr video mode Command OK! 03C02.