Contemporary Control Systems EIDX Managed Automation Switches Installation Guide for Non-PoE Models - Manual (Page 7)

TD071105-0IA
7
LED Indicators
Power — This LED glows green when proper power is applied to the EIDX.
Status — This bicolour LED will be green in an operational state and red in a
fault state. The green LED blinks periodically to indicate the management CPU
is fully operational.
Port — Each port has an associated bicolour LED which glows green when a
valid Ethernet link has been established at 100 Mbps but yellow if the data rate
is 10 Mbps. The LED flashes when data transfer is occurring.
Port Locations
Ports 1–8 are accessed on the front panel. Other ports
are located on the bottom of the enclosure — and
for 24-port models, also on the top surface.
An example of port arrangement on the top and
bottom of the enclosure is shown in Figure 6
which locates a few of the ports on the model
EIDX24M-100T/FC.
Fault Relay
This relay is disabled by default. Its operation is
explained in the Software Manual. Its contact is
normally closed and rated at 500 mA, 24 V (max).
Figure 9 — Port Locations
Console Port
The Console Port uses the standard RS-232 protocol for
configuring the switch. For proper communication :
Set the Baud rate to 9600.
Set the Data bits to 8.
Set the Parity to None.
Set the Stop bits to 1.
Set the Flow control to None.
Figure 10 — Console Port