ConnectGear GP-10P - Manual (Page 54)

User's Manual
14. Set the Banner type to PostScript if you are using a PostScript
printer, and to Text otherwise.
15. Press F10 to save the new configuration.
16. Reset the PrintSir to have the changes take effect.
NOTE: The PrintSir may require up to a minute after power-up to log
into a NetWare Directory Services context because of the large
number of calculations NDS security requires.
Your PrintSir should now be ready for use by workstation users. You
should be able to redirect printing to your PrintSir using a CAPTURE
command.
5.3.2.2 Configuring as Remote Printer Mode
This remote printer feature is not available for the 10/100Mbps 3-port
PrintSir models. Make sure that you have created the NetWare print server
with Type Remote using PCONSOLE utility before you configure the
PrintSir. For more detailed information about PCONSOLE, please refer to
NetWare‘s manual. You can set up the NetWare print server, print queue
and printer objects by following the steps below:
1. Run the NetWare PCONSOLE program.
2. Change the current context, if necessary, using the Change
Context menu selection.
3. Choose Quick Setup from the menu.